Ordinary wooden folding production process edit this section. First, buy a sheet and then processed into the same thickness of the plate, the surface should be smooth, and paddled like sawing, splicing it with ordinary white latex better. Then fixed, after a day it did. Secondly, the process of wood was polished look good, and then grant the putty, sanding a day, if uneven batch and then polished again, be sure to smooth the paint because it depends on the smooth and flat. The last is on the primer, sanding a day, you can water sandpaper, 600 start, then paint and then polished 600 or more, until smooth feel. Finally, paint brush, thin and uniform. Over a one week even completed. Finally, you can draw some beautiful patterns on the wooden box. If you have special requirements but also specifically patterned plate, to make a good pattern soak it for a few seconds, out to be affixed directly on the wooden box, then use the scraper to hang out inside the water, stood Less than 10 hours later, then the top layer of plastic film lightly thrown, cast over the finish line.